Water pump replacement, power steering bracket
#1
Member
Thread Starter
Join Date: Jul 2011
Location: California
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro RS
Engine: 305 TBI L03
Transmission: Auto
Axle/Gears: 2.73
Water pump replacement, power steering bracket
Wassup guys I'm trying to replace my water pump & I got it off. But I think to torque it down right I have to take the power steering off because the socket doesn't fit, it hits the bracket. So my question is which bolts do I take off? Is it only the two nuts (14mm or 9/16") & two torx bolts (T?) It's a 92 305 tbi
#2
Supreme Member
Join Date: Jul 2009
Location: Kitchener, ON
Posts: 2,327
Likes: 0
Received 7 Likes
on
5 Posts
Car: 1988 GTA
Engine: LB9
Transmission: T5
Axle/Gears: 3.45
Re: Water pump replacement, power steering bracket
Shouldn't have to remove the bracket to get the water pump on. That bracket is a bit of a pain to remove. In addition to the nuts, there will be one or 2 braces against the exhaust manifold and intake.
#4
Member
Thread Starter
Join Date: Jul 2011
Location: California
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro RS
Engine: 305 TBI L03
Transmission: Auto
Axle/Gears: 2.73
Re: Water pump replacement, power steering bracket
So have you guys done this? It might be that my sockets a cheap one then haha. Thanks for the answers
Thread
Thread Starter
Forum
Replies
Last Post
colton_carlson
Firebirds for Sale
7
03-08-2019 12:21 PM
Zachattack0925
Tech / General Engine
2
08-12-2015 09:54 PM
Zachattack0925
Transmissions and Drivetrain
4
08-12-2015 09:52 PM
Street Lethal
Engine/Drivetrain/Suspension Parts for Sale
0
08-12-2015 11:33 AM