larry88ttops

1988 Camaro TBI V8

GeneralDisorder

iTrader: (1)

Yes! Yes you absolutely can change the thermostat. Go ahead you have our permission.

GD

Tuned Performance

iTrader: (92)

Lmao

larry88ttops

Yeah - I know this came off as kinda lame! I have changed the cam, the heads, the intake, the chip, the rear end gears, modified the TBI, installed headers and a cat back - lots of stuff to this car in the past 17 years. But here lately, I've had this pesky leak right around the thermostat housing and it's driving me nuts! I've changed the thermostat a couple of times and tried several methods and types of gaskets. What I'm going to do tomorrow is take the hold down screws out and give them a good coating of Form-a-Gasket, as I suspect that they screw down into the water jacket. That was why I was asking about the procedure, to see if this was the case.
So let the sarcasm continue - just be gentle!

Drew

iTrader: (58)

Pull the intake to head bolts in that corner. Clean the threads and use thread sealer.

larry88ttops

Thank you, sir!
I am looking for any ideas here!
I will do this in addition to pulling out the hold down bolts and smear sealer on everything!

sofakingdom

iTrader: (1)

Replace it.

http://www.autozone.com/cooling-heat...848184_13975_0

The one for your car probably costs about the same.