Can someone run a few cams through desktop dyno for me?
03-27-2002, 09:44 PM
#1
Senior Member
Thread Starter
Join Date: Oct 1999
Location: New Britain, CT, U.S.A
Posts: 566
Likes: 0
Received 0 Likes
on
0 Posts
Car: '87 IROC
Engine: LT1 350
Transmission: 700-R4
Can someone run a few cams through desktop dyno for me?
Ok, It's between these three cams. Here's my motor so far: Stock LT1 bottom end, LT1 intake (but using batch fire injection), CR is between 10.5-11.0, and Flow numbers on the heads are:
i.200" 135.0
i.300" 201.0
i.400" 249.0
i.500" 275.0
i.600" 280.0
e.200" 110.0
e.300" 157.0
e.400" 180.0
e.500" 195.0
e.600" 208.0
The three cams I'm looking at are these:
LPE219 cam: 219/219 .560"/.560" 112LSA
CC306 cam: 230/244 .544"/.576" 112LSA
GTP 6 cam: 235/242 .568"/.592" 114LSA
Also can you tell me what the powerband of these cams should be about? Thanks
i.200" 135.0
i.300" 201.0
i.400" 249.0
i.500" 275.0
i.600" 280.0
e.200" 110.0
e.300" 157.0
e.400" 180.0
e.500" 195.0
e.600" 208.0
The three cams I'm looking at are these:
LPE219 cam: 219/219 .560"/.560" 112LSA
CC306 cam: 230/244 .544"/.576" 112LSA
GTP 6 cam: 235/242 .568"/.592" 114LSA
Also can you tell me what the powerband of these cams should be about? Thanks
03-27-2002, 10:05 PM
#2
Senior Member
iTrader: (1)
Join Date: Dec 2000
Location: chicago
Posts: 689
Likes: 0
Received 0 Likes
on
0 Posts
intake centerline
i need the intake centerline degrees also.it might the same as the lsa.or if u have the exact degrees of openings(btdc,abdc etc).what kind of lifter(hydraulic,solid,roller)
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
12-02-2016 06:33 PM