Carb intake converted to multi-point
#1
Senior Member
Thread Starter
Join Date: Jul 1999
Location: Brevard Florida
Posts: 686
Likes: 0
Received 0 Likes
on
0 Posts
Carb intake converted to multi-point
My Mult-point conversion is finially running... thought you guys might like this. Its an Edelbrock Victor Jr on AFR 195 heads with a 700cfm Holley tb unit that I had from a previous project (minus the TBI injector pod). I'm running DFI.
Had I used AFR 190's instead of the taller port 195's I could have used an off the shelf intake and would not have had to farm out the intake conversion. Putting together the braided hoses was easy. I just plugged off the fuel line inlets into the TB unit. I drilled a couple of holes in a 1" spacer for my vacuum ports. I'm running a 2 1/2" drop base air cleaner. This would probably fit under a stock hood if it werent for the spacer.
http://www.fbody.com/members/workman/MultiPoint1.JPG
http://www.fbody.com/members/workman/MultiPoint2.JPG
http://www.fbody.com/members/workman/MultiPoint3.JPG
Had I used AFR 190's instead of the taller port 195's I could have used an off the shelf intake and would not have had to farm out the intake conversion. Putting together the braided hoses was easy. I just plugged off the fuel line inlets into the TB unit. I drilled a couple of holes in a 1" spacer for my vacuum ports. I'm running a 2 1/2" drop base air cleaner. This would probably fit under a stock hood if it werent for the spacer.
http://www.fbody.com/members/workman/MultiPoint1.JPG
http://www.fbody.com/members/workman/MultiPoint2.JPG
http://www.fbody.com/members/workman/MultiPoint3.JPG
Last edited by Dan W; 06-29-2002 at 11:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM