Couple LT1 intake swapping Q's
#1
Member
Thread Starter
Join Date: Oct 2001
Location: Anderson, IN
Posts: 414
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Cutlass
Engine: 350
Transmission: 200-4R
Couple LT1 intake swapping Q's
I know there's been tons of threads on the swap, but I couldn't really find any info on this stuff.
1. My supply fuel line does not want to "click" into place. It will kind of snap in, but it pulls right off. I've take the plastic clip off and tried to bend out the tangs inside of the line, but it still will not click. Any ideas?
2. Did you have to modify the throttle cable bracket? It looks like it'll need cut to fit the throttle cable.
The main problem I'm having is #1, I spent a couple hours playing with it and haven't had any luck. Thanks for any help.
1. My supply fuel line does not want to "click" into place. It will kind of snap in, but it pulls right off. I've take the plastic clip off and tried to bend out the tangs inside of the line, but it still will not click. Any ideas?
2. Did you have to modify the throttle cable bracket? It looks like it'll need cut to fit the throttle cable.
The main problem I'm having is #1, I spent a couple hours playing with it and haven't had any luck. Thanks for any help.
#2
Supreme Member
Join Date: Aug 2001
Location: Orygun
Posts: 2,747
Likes: 0
Received 0 Likes
on
0 Posts
On mine there can sometimes be a first click, if you push it harder and further then you will really get the fuel lines seated
For an auto use a 93 LT1 bracket, and mine needed to be tweaked a tad to hold the throttle cable in place but the bracket was used.
For an auto use a 93 LT1 bracket, and mine needed to be tweaked a tad to hold the throttle cable in place but the bracket was used.
Thread
Thread Starter
Forum
Replies
Last Post