Installing a cam, have a few questions.
03-17-2004, 12:59 PM
#1
Member
Thread Starter
Installing a cam, have a few questions.
I want more power so I figured I would go with a different cam. The one I found is Crane PowerMax it has 204/214 duration and .423"/.446" lift. I heard that you dont want more than .430 lift so is that going to be to much. I want a cam that is as big or a little bigger than the cam in the 305 manuals and the other cams that ive found are a little smaller. Also will I have to worry about the computer not working right with this cam. THANKS
------------
1989 Trans am 305 TPI Automatic, 2.73 rear, K&N filter, underdrive pulleys, air foil, tb bypass, low restriction exhaust
------------
1989 Trans am 305 TPI Automatic, 2.73 rear, K&N filter, underdrive pulleys, air foil, tb bypass, low restriction exhaust
03-17-2004, 01:44 PM
#2
Supreme Member
Join Date: Sep 2001
Location: Flowery Branch, GA
Posts: 1,195
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Iroc-Z
Engine: 1 BA 305 TPI
Transmission: Probuilt 700R4 - 2800 Stall Midwest
Axle/Gears: 3.42
Personally, I think the cam is too small considering all the trouble you have to go through to replace the cam. The computer shouldn't have a problem. That cam isn't much different than the stock cam that cam in my 305. But since you don't plan on doing the heads that cam should work fine. I am changing my cam and from what I have heard the stock heads will be a big restriction so I plan on doing them at the same time as the cam. I'm using either a 212/218 cam or 218/224 CompCam XE.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM
84z96L31vortec
North East Region
1
08-10-2015 08:27 PM