HSR and injector clips
07-23-2004, 11:24 PM
#1
Supreme Member
Thread Starter
HSR and injector clips
It's my 1st time putting one of these togethor.
I pieced togethor a HSR and used their rail kit.
Do I need to use injector clips?
What do I need to watch out for?
What TB's fit besides that $600 Holley one?
My 58mm BBK throttle cable guide rail hits the crossover fitting.
I pieced togethor a HSR and used their rail kit.
Do I need to use injector clips?
What do I need to watch out for?
What TB's fit besides that $600 Holley one?
My 58mm BBK throttle cable guide rail hits the crossover fitting.
07-24-2004, 12:25 AM
#2
Supreme Member
Join Date: Aug 1999
Location: San Diego, CA
Posts: 1,053
Likes: 0
Received 2 Likes
on
2 Posts
Car: 87 Buick GN
Engine: 3.8L (231 cid) V6
Transmission: 200-4R
Axle/Gears: 10 bolt G80/ 3.42
No need to use the injector clips, plus the HSR fuel rails are not machined to use them.
The throttle body hitting the fuel fitting seems like a common problem using the later style cable guide.
I had the same problem too, but is easily fixed-
https://www.thirdgen.org/techbb2/sho...hreadid=165634
The throttle body hitting the fuel fitting seems like a common problem using the later style cable guide.
I had the same problem too, but is easily fixed-
https://www.thirdgen.org/techbb2/sho...hreadid=165634
Thread
Thread Starter
Forum
Replies
Last Post
