MrJ

It's very odd. I can install both runners loosely, and when I drop the plenum between the runners to bolt it in, I can't get damn thing to line up. It will line up fine on the driver's side, but on the pass. side it wants to sit crooked. I've spent about 5 hours so far on this with no luck. I've tried every method that I can think of. When I was removing the pass. side runners, I didn't know that there was that one bolt that had to be accessed from the opposite side, so I pryed the hell out of the runners in an attempt to remove them. I think this may be part of my problem. What can I do to get all this stuff installed?

------------------
91 Trans Am WS6
Bright White
5.0 TPI auto
Flowmaster 3" 2 chamber catback
Trans Go shiftkit
2000 stall converter

Built on Wednesday

86TpiTransAm

Pray!

ColinOpseth

you pryed??

*tisk tisk tisk* you forget the whole TPI setup is soft aluminum...



------------------
Webmaster: www.IROC-Z.org

MrJ

Looks like the sledgehammer is gonna become my best friend...

72BuickGSX

hehe yeah its a bitc# i had problems with mine untill i realized that the bolts are diffrent lengths , so when we worked on my cousion 89 formula i keep everything exactly the way i took it off and and it went back on fine, hope this helps

91banditt2

iTrader: (1)

i know this may be a stupid question but are you putting the runners on the side that they are supposed to be on?they are both different!

------------------
1991 banditt2 #130 of 600
Project 350 TPI Banditt II
http://www.street-dawg-racing.cityslide.com
http://photos.yahoo.com/tonysams72
http:/discussion-board.com/GreaterCincinnatiFBodyAssociation/

MrJ

of course they are on the right sides. The one with the small extra tube goes on the passenger side, the other on the driver's side.