raven350

What is a good way to cut braided hose?

The company I can get it from will not cut it and only sells it in pre-cut lengths....

irocbsa

Wrap electrical tape around where you want to cut and go at it with hack saw with a fine toothed blade.
bsa

------------------
"If they do not run, Then they will die." - Stonewall Jackson
#3
'87 IROC, 355 TPI, Converted to SD, 700R4, B&M Megashifter, 3.42, Trick Flow Twisted Wedge Heads, Edelbrock Intake, Accel Runners, Comp Cam, Crane Gold rockers, Lucas 23# injectors, Edelbrock headers, Flowmaster 3'' exhaust, Mallory Ignition, Transgo Performance Shift Kit, Corvette Servo, 2,000 Stall Torque Converter

MikeS

i'd replace the hacksaw with a bandsaw if you can. cuts back on the back and forth that might rag it out. Not sure how to make the end look finished though. I guess a crimp on thing

IROCKZ4me

After taping the area to be cut I use an air powered cutoff tool (the kind with a little 3 inch fiber metal cutting wheel). It leaves the cleanest cut and is fast

------------------

Tracy /AKA IROCKZ4me
'86 IROC-Z Camaro
"Cogito ergo zoom"

• 355 cid
• AFR heads
• Arizona Speed & Marine hydraulic roller cam w/ AFR hydra-rev kit
• modified SLP runners
• TRW forged pistons/ceramic coated
• fully balanced
• Edelbrock headers/ceramic coated
• SLP cat-back
• Paxton supercharger
• Nitrous Express nitrous oxide

EFI Performance Club on Yahoo