knock sensor problem
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2005
Location: michigan
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 iroc vert-91z-28
Engine: 305 tpi-305 tpi
Transmission: 700r-4-700r-4
Axle/Gears: 3.23 posi-3.73 posi
knock sensor problem
i have a 91z 305tpi. as soon as i start my car, the ses light comes on and stays on. pulled code 43. its been like this since i got it. i recently tested the voltage going to knock sensor, and it was good. then i checked the ohms of the knock sensor and get nothing. it runs alright with a slight miss on occasion while cruising and under wot it seems like its lacking some power. it runs pretty good, i just think that its not all there. my question is how much power will a bad knock sensor rob me of? i plan on replacing the sensor when i install my headers later on, but if it'll make a big difference in how my car runs i'll change it now. i have a hypertech chip that was in it when i bought it, cat delete with flowmaster cat back, shift kit, 3.73 posi, k&n, and i can't even chirp the tires from a dead stop. like i said, i bought the car this way, so i can't compare how it ran before the code 43. thanks
#3
Senior Member
Join Date: Mar 2009
Location: Brick, NJ
Posts: 870
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Trans Am
Engine: 355 TPI
Transmission: Built T-5
Re: knock sensor problem
it will rob you of a lot of power because the timing isn't advancing like it sould, i would replace that knock sensor
Thread
Thread Starter
Forum
Replies
Last Post
Chuck84TA
Engine/Drivetrain/Suspension Parts for Sale
10
07-15-2016 09:05 PM