Crane Hi-6s misfire
#1
Member
Thread Starter
iTrader: (5)
Join Date: Feb 2005
Location: Bolivar, TN
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 GTA
Engine: 350
Transmission: 700R4
Axle/Gears: 3.27
Crane Hi-6s misfire
Ok I brought a Crane Hi-6s, map sensor, and timing controller, a while back so I can use it to help control timing underboost till I switch ecms. Well anyway I have just tried hooking up the box with out all the add-ons and the thing is missing from idle-1500 and above 4400 rpms. I did exactly what it recommends I replace coil with the Crane FIREBALL that I brought with the box, plus I put new magnetic pickup, ignition module, cap, rotor, Taylor Thundervolt 8.2mm wires, sparkplugs. And the thing still misses, I also installed a relay kit to ensure that the box was getting correct voltage and it still misses. I dont know what is going on.
Of course I can't get Crane tech support since they aren't doing that anymore. LMAO.
So any suggestions on what could be wrong? The car isn't turboed yet, it has bolt-ons thats it. Car doesn't miss fire without box hooked up.
Also Car is 89 GTA 5.7L with mods in sig.
Thanks
Jason
Of course I can't get Crane tech support since they aren't doing that anymore. LMAO.
So any suggestions on what could be wrong? The car isn't turboed yet, it has bolt-ons thats it. Car doesn't miss fire without box hooked up.
Also Car is 89 GTA 5.7L with mods in sig.
Thanks
Jason
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM