Modify 87 TPI base for 84 heads?
06-13-2010, 08:47 PM
#1
Senior Member
Thread Starter
iTrader: (8)
Join Date: Jul 2006
Location: Davisburg, MI
Posts: 683
Likes: 0
Received 1 Like
on
1 Post
Car: 87 Evoluzione, 84 TransAm, 05 GTO
Engine: LT1, L98, LS2
Transmission: (2) T56 & (1) 700R4
Axle/Gears: Moser 12-bolt w/3.73 & Stock
Modify 87 TPI base for 84 heads?
I've talked my daughter into converting her 84 T/A to FI. I'm supposed to pick up a TPI system from an 87 IROC this weekend. Most sites say I need a non-roller block base (85, 86 F-body or aluminum head Corvette). I've seen some hints that the center mounting holes can be modified. What about the EGR passages? Which base gasket would I use?
06-14-2010, 08:14 AM
#2
Supreme Member
iTrader: (13)
Join Date: Apr 2005
Location: Not in Kansas anymore
Posts: 7,732
Likes: 0
Received 11 Likes
on
11 Posts
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Modify 87 TPI base for 84 heads?
You just slot the the two center holes in the F-Body intake to suit the different bolt angle used on the regular SBC heads.Might need a washer under bolt head
Intake gasket is the same; only the angle of the center bolts differs .
72 degrees vs 90 degrees on pre '86 iron and Vette alum heads
Intake gasket is the same; only the angle of the center bolts differs .
72 degrees vs 90 degrees on pre '86 iron and Vette alum heads
06-15-2010, 06:17 AM
#3
Senior Member
Thread Starter
iTrader: (8)
Join Date: Jul 2006
Location: Davisburg, MI
Posts: 683
Likes: 0
Received 1 Like
on
1 Post
Car: 87 Evoluzione, 84 TransAm, 05 GTO
Engine: LT1, L98, LS2
Transmission: (2) T56 & (1) 700R4
Axle/Gears: Moser 12-bolt w/3.73 & Stock
Re: Modify 87 TPI base for 84 heads?
Thanks, I should have checked Rock Auto to see same gasket used.
Thread
Thread Starter
Forum
Replies
Last Post
NinjaNife
Tech / General Engine
27
08-23-2015 11:49 AM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
08-12-2015 03:41 PM
