Bad batch of Edelbrock baseplates
#1
Supreme Member
Thread Starter
iTrader: (2)
Join Date: Nov 1999
Location: Monroe,NC
Posts: 1,779
Likes: 0
Received 20 Likes
on
15 Posts
Car: 90 Formula
Engine: 305
Transmission: 700R4
Axle/Gears: 9 bolt/3.27
Bad batch of Edelbrock baseplates
Does anyone know about when the supposed batch of bad Edelbrock baseplates (3860) were produced? I've been reading of recent problems with the base such as leaking and holes being drilled too deep etc. and I'm trying to figure out if the one I have is one of them. I bought it unused from a member here about 3+ years ago and now am concerned it may be one of those defective ones. Thanks in advance.
#2
Supreme Member
Re: Bad batch of Edelbrock baseplates
This is the only thread I can recall. Note the posting dates.
https://www.thirdgen.org/forums/tpi/...-manifold.html
There was another one recently on the General Engine/Tech board.
https://www.thirdgen.org/forums/tpi/...-manifold.html
There was another one recently on the General Engine/Tech board.
#3
Supreme Member
Join Date: Feb 2006
Location: Sanctuary state
Posts: 1,780
Likes: 0
Received 27 Likes
on
24 Posts
Car: 67 ******mobile
Engine: 385 Solid roller
Transmission: T-56
Axle/Gears: 4.11
Re: Bad batch of Edelbrock baseplates
Eddy may be able to tell you
Take a flat edge to it see if you can mock it up on someones motor if thats possible. Holes easy to correct.
Sometimes the molds get old. Ive worked on a # of their new BBC intakes and the ports need a good deal of correcting. Easily done but still
Nothings bolt on lol
Good luck!
Take a flat edge to it see if you can mock it up on someones motor if thats possible. Holes easy to correct.
Sometimes the molds get old. Ive worked on a # of their new BBC intakes and the ports need a good deal of correcting. Easily done but still
Nothings bolt on lol
Good luck!
#4
Supreme Member
Thread Starter
iTrader: (2)
Join Date: Nov 1999
Location: Monroe,NC
Posts: 1,779
Likes: 0
Received 20 Likes
on
15 Posts
Car: 90 Formula
Engine: 305
Transmission: 700R4
Axle/Gears: 9 bolt/3.27
Re: Bad batch of Edelbrock baseplates
I've read those which led me to post here. Any chance anyone has more info on this?
Thread
Thread Starter
Forum
Replies
Last Post
mrestrictrplate
Engine/Drivetrain/Suspension Wanted
3
09-21-2015 11:24 AM
toronto formula
Engine/Drivetrain/Suspension Parts for Sale
3
09-10-2015 07:31 AM