KTRE 12 bolt for 3rd gen Camaro / Firebird - Third Generation F-Body Message Boards

BlownBird · 06-15-2006, 07:14 PM

For sale is one KTRE 12 bolt for the third generation Camaro and Firebird.

-Nodular iron center section w/nodular iron caps
-33 spline Moser spool and axles
-Rear has ford big bearing ends and Timkin bearings
-3.73 gear ratio
-Has Moser stud girdle heavy duty cover
-Factory ws6 rear disc brakes and lines are included
-Rear is 60 inches brake hat to brake hat with 5/8 stud upgrade
-A Wolfe Racecraft Single swaybar and Spohn lower controll arm relocation brackets have been installed.

Wolfe Race Craft
- Detail
Spohn Performance, Inc.

Professionally assembled, and 100% complete and ready to run!
I have been 8.77@163 with this rear. It is a very nice peice, i am sad to have to part with it.

First $1700 takes it!
Don Barnett
dtb400@msn.com

Shred · 06-15-2006, 08:07 PM

will 12 bolts fit in later 3rd gen camaros? I have a 86' and i was told that a 12bolt will not fit

Air_Adam · 06-15-2006, 08:37 PM

If a 9" will fit, I don't see why a 12 bolt can't. You can't bolt in just any 12 bolt though, since they never built a 12 bolt with the proper 'mods' for use in a 3rdgen... meaning no mounts for the coil springs, panhard bar, or torque arm. You have to either modify a GM 12 bolt, or buy an aftermarket one for a 3rdgen F-body.

BlownBird · 06-15-2006, 09:00 PM

This is a third gen specific 12 bolt. It has the mounts for TQ arm, panhard bar and lower controll arms.
DonB.