Whats going on with my axle bearings?
03-05-2007, 12:17 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: Jul 2006
Location: Phoenix
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Pontiac trans-am
Engine: building a 400
Transmission: 700r4
Whats going on with my axle bearings?
I don't know alot about rear ends but I know this is not right. Can anyone tell me what went wrong here? These are new axles from a Strange S60 I noticed this when I was fabricating brake mounts to fit my bear +2 rotors. One bearing is pressed on 9.23 mm more than the other. so the brakes fit on one side and not the other every time I call Strange they act like I'm full of it.
03-05-2007, 03:25 PM
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,140
Received 1,692 Likes
on
1,286 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Looks kinda like the one on the right needs to go on about 3/8" farther.
See my signature for helpdful advice.
See my signature for helpdful advice.
03-06-2007, 02:30 PM
#3
Member
Thread Starter
iTrader: (1)
Join Date: Jul 2006
Location: Phoenix
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Pontiac trans-am
Engine: building a 400
Transmission: 700r4
Thanks you where right, I guess its the one on the right they left the "wedding ring" in. I sent them pics and they finally believed me that something was wrong looks like they are going to make it right now.
Thread
Thread Starter
Forum
Replies
Last Post