torque converter wont lockup
04-11-2012, 07:59 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: Feb 2012
Location: vicksburg,mississippi
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 z28
Engine: 350 hsr
Transmission: probuilt 700r4/edge 2800
Axle/Gears: stock 4th gen 3.23
torque converter wont lockup
I just finished my stealth ram installation and now my torque converter wont lock up...... the shifts are all fine and it goes into overdrive but the converter wont lock.....once the tv cable was installed on the stealth ram it was at a weird angle and is not straight on like it was with the tpi....could this cause it to not lock up??? Removing the TV cable is the only thing IV changed since my tear down and before it was doing just fine
04-11-2012, 08:04 PM
#2
Supreme Member
Re: torque converter wont lockup
not having your TV cable set correctly will burn your tranny up in no time. be patient, do it right.
04-11-2012, 08:15 PM
#4
Member
Thread Starter
iTrader: (1)
Join Date: Feb 2012
Location: vicksburg,mississippi
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 z28
Engine: 350 hsr
Transmission: probuilt 700r4/edge 2800
Axle/Gears: stock 4th gen 3.23
Re: torque converter wont lockup
Its set and the shifts are good they are spaced out and the shift points seem to be normal bit only the torque converter wont lock up....I'm gonna check the plug on the. Tranny but I don't see how it could have come loose by Sitting in the shop
04-11-2012, 08:18 PM
#5
Supreme Member
Re: torque converter wont lockup
Removing the TV cable is the only thing IV changed since my tear down and before it was doing just fine
Thread
Thread Starter
Forum
Replies
Last Post
