Crossfire and my TV cable
01-08-2002, 08:51 PM
#1
Senior Member
Thread Starter
Crossfire and my TV cable
I have a 91' TBI Camaro that I'm swapping a fully ported ( yes I'm adding that little part so I don't get flamed 
) Crossfire Injection setup into. So here's my question, what TV cable do I use? I don't have the original CFI cable ( it was a 200C anyway ) but I do have the correct bracket for the new intake. Will my old one work? Can I use the adjustment method I saw on here to get it adjusted right?
) Crossfire Injection setup into. So here's my question, what TV cable do I use? I don't have the original CFI cable ( it was a 200C anyway ) but I do have the correct bracket for the new intake. Will my old one work? Can I use the adjustment method I saw on here to get it adjusted right? 
01-10-2002, 04:18 AM
#3
Supreme Member
Join Date: Feb 2001
Location: Webster, N.Y.
Posts: 1,730
Likes: 0
Received 0 Likes
on
0 Posts
I don't have a number for a cable but the best way to know if the TV is right is to have the pan off and have someone WOT the pedal (engine off of course!). Look at the TV linkage and when adjusted properly (yes the posted method works) the lever that pushes the plunger should be FULLY seated against the outer plunger sleeve. When released there should not be tension on the plunger. Sometimes the link is not the correct leangth and you can't get full travel on it too.
Thread
Thread Starter
Forum
Replies
Last Post
TMZIrocZ350
Engine/Drivetrain/Suspension Parts for Sale
1
10-07-2015 12:09 PM
