Spark Issue, runs for 1 min then no spark
11-04-2014, 10:10 AM
#1
Junior Member
Thread Starter
Join Date: Mar 2014
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Spark Issue, runs for 1 min then no spark
91 camaro rs 3.1. Check spark from coil and I have spark turn it on runs perfect for 1-10min then dies randomly, I check spark again from coil and I have no spark, replaced ign coil, pickup assembly, icm twice each. Still no lead way I let it sit for an hour and i have spark again but it does the same thing. Just replaced ignition switch and didn't help at all, tried disconnecting battery didn't help but I did have spark as soon as I connected it back, checked all my grounds scraped the metal to get better connection. New plugs wires... Security light doesn't flash and it does crank but it won't turn over. Obviously exactly what it does when everything works but whatever's causing no spark Thank you for your time. I desperately need help.
11-05-2014, 08:55 AM
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,410
Likes: 0
Received 218 Likes
on
204 Posts
Car: check
Engine: check
Transmission: check
Re: Spark Issue, runs for 1 min then no spark
Check/replace the two wire pigtail that goes between the coil and the ICM. They are known to have the wire break inside of the insulation. Looks OK, but is bad.
The break is usually where the wires exit the coil end connector.
RBob.
The break is usually where the wires exit the coil end connector.
RBob.
11-05-2014, 09:21 PM
#3
Junior Member
Thread Starter
Join Date: Mar 2014
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Re: Spark Issue, runs for 1 min then no spark
I checked with multimeter and had connection even when I wiggled it on both ones I'll check again and try, I can't find just the wire anywhere autozone just sells the plug into the icm. Any ideas?
11-18-2014, 10:08 AM
#6
Junior Member
Join Date: May 2010
Location: Idaho
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92Camaro 89 Blazer
Engine: 3.1L Turbo
Transmission: T5
Re: Spark Issue, runs for 1 min then no spark
I had a similar issue in a 92 3.1 rs. After a strange turn of events i ended up grabbing the ecm just right with the key on and everything turned on. If I gave the ECM a slight flex the car would start and run. That's a pretty wild and out there idea though.
When you replaced the ICM did you use the white heat sink paste underneath it? I have heard of instances where people replace them and they go out shortly after due to heat.
When you replaced the ICM did you use the white heat sink paste underneath it? I have heard of instances where people replace them and they go out shortly after due to heat.
12-10-2014, 04:44 PM
#7
Senior Member
Join Date: Sep 2014
Location: Los Angeles
Posts: 732
Received 33 Likes
on
25 Posts
Car: 92 Z28
Engine: Ramjet 350
Transmission: T-56
Axle/Gears: 3.23 Torsen
Re: Spark Issue, runs for 1 min then no spark
I had an issue were it would turn on run for one second and turn off. And would turn off when i would slow down ... Turned out the bolts on my battery posts were loose. Its soetimes something simple
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM