Help me with a wheel fitment
08-29-2013, 01:51 PM
#1
Member
Thread Starter
iTrader: (3)
Join Date: Feb 2004
Location: Jenison, mi
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 Iroc-z camaro
Engine: 5.7 Liter
Help me with a wheel fitment
I found a setup and am looking for an expert to help me out. I don't want to run spacers!
The front is:
Offset: 15
Bolt Pattern: 5x120
Rim Width: 8.5
Hub Bore: 72.56
Rim Diameter: 18
The rear is:
Offset: 15
Bolt Pattern: 5x120
Rim Width: 9.5
Hub Bore: 72.56
Rim Diameter: 18
Thanks
The front is:
Offset: 15
Bolt Pattern: 5x120
Rim Width: 8.5
Hub Bore: 72.56
Rim Diameter: 18
The rear is:
Offset: 15
Bolt Pattern: 5x120
Rim Width: 9.5
Hub Bore: 72.56
Rim Diameter: 18
Thanks
08-29-2013, 02:15 PM
#2
Supreme Member
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,652
Likes: 0
Received 46 Likes
on
44 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: Help me with a wheel fitment
Because they are 18s th ey will fit without a spacer but you might end up with a small spacer to bring them out a little as they will tuck under a decent amount. They are 5x120 as well which is not the exact bolt pattern needed, it will work but is not ideal.
08-29-2013, 02:31 PM
#3
Member
Thread Starter
iTrader: (3)
Join Date: Feb 2004
Location: Jenison, mi
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 Iroc-z camaro
Engine: 5.7 Liter
Re: Help me with a wheel fitment
They also offer a 30 offset if that will help avoid spacers. Is there a big concern running a 5x120 over a 5x120.65?
08-29-2013, 02:59 PM
#4
Supreme Member
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,652
Likes: 0
Received 46 Likes
on
44 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: Help me with a wheel fitment
More positive offset will bring the wheel in more requiring a spacer, you would need less not more. But like I said they will fit pretty well as is
Thread
Thread Starter
Forum
Replies
Last Post
Chad Speier
Engine/Drivetrain/Suspension Parts for Sale
3
09-24-2015 12:32 PM