I'm comparing some cylinder heads and I was wondering if anybody had any flow data for the Torquer 305s made by World Products. I thought I remembered reading that Super Chevy or another magazine published flow data for these heads and I was wondering if anybody might know the issue or even have it for me.

I'm not really interested in opinions unless you have these heads on your 305, then I would appreciate some feedback. Numbers at certain lifts are what I'm really looking for. . .

Any help is appreciated,

Jason

 

lift intake cfm swirl rpm ex `.050 30.62 1265 26.93 `.100 65.84 1664 55.87 `.150 76.87 2610 82.95 `.200 123.12 2329 103.64 `.300 170.20 3840 123.24 `.400 195.36 4477 127.98 `.500 199.80 4926 129.56 `.550 198.32 4823 129.56 `comments-an economy replacement head that offers good value for the cost ,but is out gunned in our test.an undesirable head for max street use. as printed in gmhtp sept 2000

 

that did not turn out the way i had hoped i might be able to scan the article and send it to you via e-mail hope you reard it

 

Thank you for the data, that is exactly what I was looking for. If you don't mind scanning the article, I'd love to have it. If you don't feel like it, that's ok too. The numbers were what was really important. Thanks again,

Jason
jarmentro@radford.edu

 

There are two other topics that specifically relate to 305 heads in this section.
-- what other heads are you comparing to the world 305's???

james

------------------
88 T/A 305 TPI--
K&N,Air foil,hypertech chip, thermostat+fanswitch
no MAF screens, no cat, dynomax exh, urethane motor+trans mounts,
SSM frame con, Bilsteins
homemade ramair.