anyone know where I can send a LT1 intake to get the distributor hole only drilled? and I will be needing a angled spacer, but I figure I should be able to get that from the same place


if no ideas, here is a question, are the rear intake bolt holes in the same location on a standard SBC intake as on the LT1 intake? i am asking so if needed, I can check local machine shops and see if one can do it, after locating the hole off one of the SBC intakes I have

 

https://www.thirdgen.org/forums/engi...ntake-4-a.html

Theres alot more to it than just cutting a new hole for the distributor
Buy a kit from this guy and have no worries or do the research you obviously havent and DIY for about the same if not a little more cost

 

actually, yes, all i need is the hole and spacer, as this will be on an LT1 engine