Hogan's Custom Sheet Metal Intake
Thread Starter
Junior Member
Joined: Feb 2009
Posts: 1
Likes: 0
Car: 1969 Camaro Convertible
Engine: All aluminum 540
Transmission: TKO 600
Axle/Gears: Ford 9" with 3.70 gears
Hogan's Custom Sheet Metal Intake
Here is an alternative you may not have seen. This is a Hogan's sheet metal manifold I had custom made. Custom tapered runners provide good low end torque, and top end HP. Total Manifold height is 7.5", which is 1" shorter than TPI. It is designed for SBC, and 1205 gaskets. Here are some pics. I am actually trying to sell it, as I have sold the project it was going into. My cost was $3400 all in. I am asking $2500 OBO. PM me if interested.
Last edited by bthibodeaux; Feb 25, 2009 at 02:24 PM. Reason: added to description
Joined: Feb 2007
Posts: 4,770
Likes: 64
From: Trumbull CT
Car: 87 TA clone
Engine: 70/70 Turbo 5.3 LS
Transmission: bullet proof 2004R
Axle/Gears: ford 8.8, 3.55 gears
Re: Hogan's Custom Sheet Metal Intake
that thing isss sooo frigin sexy... would look great with my fabricated valve covers! d@mn its soo pretty... but sooo expensive! good luck tryin to sell that thing
Last edited by anesthes; Mar 16, 2009 at 12:14 PM. Reason: text edit. minor innapropriateness.
Joined: Jun 2008
Posts: 160
Likes: 0
From: Waterloo, Iowa
Car: 1987 Pontiac Trans AM GTA
Engine: 5.7 LTR
Transmission: Automatic
Re: Hogan's Custom Sheet Metal Intake
...
Last edited by anesthes; Mar 16, 2009 at 12:14 PM. Reason: just plain stupid...
Thread
Thread Starter
Forum
Replies
Last Post
gixxer92
Engine/Drivetrain/Suspension Parts for Sale
5
Sep 1, 2015 04:32 PM
Dialed_In
Firebirds for Sale
2
Aug 20, 2015 01:45 PM
