....I just took these pics like 20 mins ago and about 3-4 hours ago i put new KYB Gr2 struts, KYB just -a-shocks and moog coil springs in the rear. and i think it sits too high, like to the point where i can fit more then my head under there and to reach at things. like if i wanted i could change my oil with out a jack.

is that how its supose to be like stock ride hight? the front end is rebuilt with new coil springs and then the things i just told ya's about. oh well all i know is i got plenty of room when i put my hooker supercomp long tubes on and i wont have any ground clearence problems.

 

2.

 

3. this is the last one

 

I think you should drive it for a while, and tomorrow it might settle down more, ever time I do shocks it allways seems high at first for a while untill the "settle".

 

i think it is supposed to be like that i have new springs and shocks in the back but not the front and look how it sits...

<img src="http://images.cardomain.com/installs/192000-192999/192436_78_full.jpg">

 

It should settle down a few inches once it gets some miles on the suspension. It looks a little high about where mine is at right now. Man 1986CamaroSC, your car looks kinda mean with that stance.

 

ok kool. i figured it "should" settle soon i just hope it does alittle. and yea 1986camaroSC that does look mean like that but must suck becuz u proably scrape on alot of things

 

Mean?? really... i have scraped it only like once, but it did a bad enough job on it...


it has been sprayed over in this pic...

<img src="http://images.cardomain.com/installs/192000-192999/192436_102_full.jpg">

 

It looks like your car is at the factory stock ride height. Most thirdgens now with the original springs have settled so much that the ride height looks lowered.

 

yea i know what ya mean. when we rebuilt my front end and were puttin in new springs the driverside spring was broken at the bottem and the other side was fine. today when we put the new springs in its like we pulled out lowerin springs. didnt have to do much to get them out just a few tuggs and pushes and they were out.

 

82chevy,

where did u get that hood!!? how much was it? i have been looking for one like that in canada, well, sask, but i cant find one

 

i think its a harwood hood

 

nice pics!

 

Well, I'm not getting new springs lol My car sits nice and level atm

 

Well hey at least your cars dont lean to the left. I would rather it be low than leaning. I need to put my SFC's on I got a wild 383.

 

Mine sits nice and level too...

~RJ~

 

Nice pics, your car looks really mean.

 

thanx guys and also it has settled a bit since then becuz i used to be able to get my entire hand (if u had it flat) in there vertically and now i can get about 3-4 fingers held flat out in there. and it looks good now also.

 

looks kinda cool.....lol....i need new front springs.....my rear HD springs i got like 2-3 inches from fender to tire but in the front its like an inch....i got coil spring spacers too.....20 yr old springs+v6 spring+ v8+A/C=dead springs

 

its always been a wonder of mine, what does A?C have to do with spirings?