scauffiel

Well, y'all have been asking for it so here they are. I just ordered this hood and it should be here next week, on my car by the following weekend. Anyways without further ado... (By the way I hope the owner doesn't mind me posting these! )




I'll post some more of mine when I get it done... WooHooHoo!

Steve

AmorgetRS

iTrader: (6)

Humm... I don't like it on the 91/92 Syle nose. I want to see it on a 85-90 TA or basemodel w/ GFX. This might sway if I buy a ASCD Ram Air or the US Body one.
Does anyone else notice it doesn't seem to fit very well in front?
Later,
RS

scauffiel

In all fairness the owner said that he had it adjusted perfectly prior to taking it in for paint. Apparently they took the hood off to shoot it, then they baked the car and hood. When it went back on there was a slight "straightening" of the natural curvature of the hood. He was, needless to say very upset. He thinks that he can get it to work without too much trouble though, which is good. I'll have this on my 1988 Trans Am by next weekend and will post more pictures of it (with the different nose cone) when I do.

Steve

MY87GTA

I was wondering were you bought the Ram Air hood and how much was it?

scauffiel

From www.usbody.com total cost will come in the neighborhood of $620'ish. Shipping will depend on fuel surcharges and such.

Steve

hookin88formula

how many inchews is the cowl? i really like the way that looks i have a 1988 formula350 i think that would look pretty good on my car.. is there any other companies that make a hood simular to that??

------------------
1988 firebird formula350tpi msd 6al box blaster 3 coil accel 8.8 wires flowmaster cat back pro shift light a pillar gauge pod and water temp and air/fuel ratio gauges b&m mega console shifter, march underdrive pullies, tpis airfoil
best 1/4 mile run of 14.44@ 96.53

burntblues

why is the hood straight across?

-=-Mike