Polishing Runners ?
Thread Starter
Junior Member
Joined: Jul 2003
Posts: 24
Likes: 0
From: Michigan
Car: 1989 Trans Am, 1986 Firebird, 1981 Firebird
Engine: 350TPI, 305, 265
Transmission: 5 spd & auto
Polishing Runners ?
Okay, okay I know this subject has been posted before but I wanted to know what everyone has used to get BETWEEN the runners when sanding.
Member
iTrader: (1)
Joined: Jul 2004
Posts: 258
Likes: 0
From: Longmont, Colorado
Car: 1985 Camaro
Engine: 350 bored 40 over
Transmission: 700-R4 Race prepped
Use a quick search and it'll yield a lot of results. Besides youd get better info on the TPI board or maybethe FAQ's.
Brett
Brett
Joined: Nov 2000
Posts: 1,420
Likes: 5
From: Byhalia MS, just south of memphis
Car: 89 Firebird
Engine: 6.0 LS
Transmission: T-56
Axle/Gears: 3.70
use strips of stand paper as mentioned but use finer and finer grits to acheive the smooth look. also being the cast version wont take much to knock down you souldn't need much sanding.
Last edited by QUICKCHICKEN; Aug 20, 2005 at 10:24 PM.
Supreme Member
Joined: Jun 2003
Posts: 1,985
Likes: 1
From: Massachusetts
Car: candy blue 85 z28
Engine: 305 tpi LB9
Transmission: 700r4 crazy beefed up one
Axle/Gears: ones with teeth
i used a trip of sabd paper and pulled it back and forth.. hope that makes scence.... run the paper around the runner and put your hands on the other side of the curve of the paper and pull back n forth..
Thread
Thread Starter
Forum
Replies
Last Post
bigjay89gta
Engine/Drivetrain/Suspension Parts for Sale
12
Oct 15, 2015 08:04 AM
Royal_Z
Engine/Drivetrain/Suspension Parts for Sale
4
Sep 30, 2015 08:45 PM