Hey guys, I was wondering if a 1996+ Camaro SS/Firehawk Hurst Shift **** would fit my 86 IROC T-5?? Like do they share the same threads and shaft size and everything?? Thanks

I was wondering this too. My GTA needs a new **** and I've been looking at the WS6 **** from RK Sport.

------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah

I have heard from various sources, and even tried to fit a t56 shifter to a t5 myself, that it would not work. The t56 base is much longer, and oblong than the t5 base..
therefore they will not bolt up, however if your referring to the **** itself, i dunno.. i dont see a reason why the **** itself wouldnt work.

-steve
92 rs/ss frankencamaro
406/t5 / i wish i had a t56
www.groundzerocustoms.org

I just re-read what you guys wrote to begin with.. IM A MORON. just wanted to clarify that as though my last post didnt.

dough!

Maybe next time ill read more carefully before replying

-steve
92 rs/ss frankencamaro
406/t5 / i wish i had a t56
www.groundzerocustoms.org[/B][/QUOTE]

Yes, the shifter ball should fit, both use 16mm x 1.5 thread. Least according to B&Ms website.

------------------
1989 Camaro RS LO3 WCT5 0-60' 2.34 1/4 15.8@87mph
http://350.StreetRacing.org
The posi unit breaker.

[This message has been edited by Get Blown ? (edited February 21, 2001).]