Cleaning intake
12-26-2007, 07:35 PM
#1
Senior Member
Thread Starter
Join Date: Jun 2007
Location: Elizabethtown,Ky
Posts: 428
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1984 camaro z28
Engine: L69 H.O
Transmission: 700r4
Axle/Gears: 3.73
Cleaning intake
Is there any way to get all of the gunk off this intake Right now im using brake clean and a wire brush but i was wondering if their was a better way 
12-26-2007, 10:32 PM
#4
Member
Join Date: Dec 2001
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Re: Cleaning intake
Skip the pressure washer.
It needs to be sand blasted, if your really worried about the finish use glass bead.
Make sure to blow all the ports with an air compressor thoroughly when finished.
It needs to be sand blasted, if your really worried about the finish use glass bead.
Make sure to blow all the ports with an air compressor thoroughly when finished.
12-26-2007, 10:33 PM
#5
Senior Member
Join Date: Jul 2005
Location: Various barns
Posts: 819
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 Camaro RS, 72 Camaro SS
Engine: 305TBI, til it pukes
Transmission: Auto
Re: Cleaning intake
Well, sandblasting will make it look new if that's what you want.
Thread
Thread Starter
Forum
Replies
Last Post
mdtoren
Tech / General Engine
0
08-16-2015 05:45 PM