I was thinking about getting the satin finish for my Pologreen RS.They're 17x9.5 with a 44mm + offset(not sure what the backspacing is in inches)I have a 4th gen rearend so the rear should be fine but i'll have to run spacers in the front.tell me what you think....


------------------
92RS

[This message has been edited by jtmiller92 (edited August 22, 2001).]

 

dunno...i'd have to see them photoshopped.

picturing it in my mind i think it would look good.

Be different, get them if you like them!

------------------
My 1988 Firebird

91k miles, 305 TBI, auto, black exterior, red interior. GTS Blackouts.
Mods: Cherrybomb cat back with stainless steel tips, K+N filter.

 

Here's a pic of the chrome ones on an Iroc.


------------------
92RS

 

I think they would look really good on your car man. Go for it! Just post pics when you get them on there!

-Roshambo

------------------
-Joe
1988 Pontiac Trans Am WS6 - 305 TPI, 700R4, 3.23 Posi, Digital Dash, Leather Seats, Maui Blue with Silver GFX, T-tops, Tinted Glass, Gutted MAF, TB Coolant Bypass, K&N Cone Filter, Hi Flo Cat, 3" exhaust from Y-pipe back, MSD Super Coil, Accel 8mm wires, L98 Aluminum Heads, Ported and Polished Plenum, Siamesed Intake, Edelbrock 3 point Strut Tower Brace.

 

hmmm,I was told today that the rear wheels would probably stick out a little with my 4thgen rear cause the wheel only has like a 6.9" backspacing....17x9.5" rim with a 44mm + offset...i'm not even going to try and do the math right now anyone around DC area know anyone with a set of these on there 4thgen...i would pay them to let me trial fit it on my car..lol