4th gen interior for 3rd gen's. How much does it normally run?
Thread Starter
Senior Member
Joined: Aug 2001
Posts: 838
Likes: 0
From: garfield, nj
Car: 86 Z28
Engine: 355 carbed
Transmission: t-5
4th gen interior for 3rd gen's. How much does it normally run?
I have been noticing that there are people putting 4th gen interiors into their 3rd gens with no problem. I assume this is a direct replacement of the center console, front seats and hopefully rear seats. Does anyone know how much this might run at a junkyard and is it only certain years that can be directly replaced. I like the way it looks in the 3rd gens and would likek to do it.
------------------
86Z28, 350 gm crate motor, Borg Warner 5 speed, hurst shifter with line-lock, 3.73's, Edelbrock heads and carb, Edelbrock headers and cat back 3" all the way, 3" cowl induction hood, and K&N air filter.
------------------
86Z28, 350 gm crate motor, Borg Warner 5 speed, hurst shifter with line-lock, 3.73's, Edelbrock heads and carb, Edelbrock headers and cat back 3" all the way, 3" cowl induction hood, and K&N air filter.
Joined: Dec 2000
Posts: 2,341
Likes: 151
From: Cincinnati,Ohio
Car: 1991 BandittII Firebird
Engine: 5.7 HSR
Transmission: 700R4
Axle/Gears: 3.27 9 bolt
the seats will bolt right in but the rest you'll need to do some fabracating.as for prices?call around and ask!
------------------
1991 banditt2 #130 of 600
Project 350 TPI Banditt II
http://www.street-dawg-racing.cityslide.com
www.gcfba.com (Greater Cincinnati F-Body Association)
http://www.cincyspeed.com/
------------------
1991 banditt2 #130 of 600
Project 350 TPI Banditt II
http://www.street-dawg-racing.cityslide.com
www.gcfba.com (Greater Cincinnati F-Body Association)
http://www.cincyspeed.com/
Thread
Thread Starter
Forum
Replies
Last Post