ive been working on this car since april. the car started off run down at the end of it life but i have been working on getting it to look good again. the main problem with it is rust the drivetrain is in great condition

 

heres a couple pics of the front bumper reinforcement before and after and the front mask straightened out all i used to straighten out the mask wask a map gas torch a heat resistant glove and time

 

completely for got about this thread for a while decided to update it after over a year got a replacement hatch for it that was in better condition, got louvers, a digital dash, gonna be repair the door frames and reskinning them got a set of nos door skins for 150 bucks. im also deleting the mechanical fuel pump and going to an electric after the mechanical ones diaphragm went bad dumped over a gallon of gas into the oil pan.

 

Nice project! Got some new pics?

 

heres a couple pics of the door skin gauge cluster and my led taillight project for my car. the white is the reverse lights on the bowtie. cant upload many i gotta get all the pics off my old computer that just went bad couple days ago.

 

I like the gauges! Where did you score those?

 

there cyberdyne gauges they arent made anymore. i was scrolling through the for sale section here last year guy had them for 35 bucks the pic doesn't even show all the lights on the gauges. around the numbers for the rpm and speedometer there is a green arch when the engine is running that lights up more and the rpms and speed goes up

 

Cyberdyne eh? Those things are BOSS! Did they use the same sending units?

 

yea if you had all gauges not dummy lights but my car had dummy lights so i had to get the sending units for the irocs and put it on my car. i also need to get a speedometer sender from dakota digital to get speedo to work since i dont drive it not on my top priority.