camaro interior ??????
Thread Starter
Junior Member
Joined: Apr 2002
Posts: 35
Likes: 0
From: San Deigo CA
Car: 1984 camaro Z28 and 1997 camaro RS
Engine: 305 HO in the Z and 3.8 V6 in the RS
Transmission: 700R4 in the Z and 5 speed in the RS
camaro interior ??????
how much should I be looking to pay for the seats front & rear and door panels
New seats... Nt exactly sure but figure on 700 buck to cover them yourself and 1500 at a shop
... And as for the panels, i would say 150 a pair.....
The site below has interiors at a decent price check it out there
here... www.thirdgenresource.com
... And as for the panels, i would say 150 a pair.....The site below has interiors at a decent price check it out there
here... www.thirdgenresource.com
thirdgen f-body parts sometimes command a premium price at the wrecking yards since they are sports cars. but you'll find some yards that treat them as just another old car and price the parts accordingly.
have acquired a couple complete sets of used thirdgen seats in nice shape in the past for $100-$150 a set. but selection is now very limited, since the majority of the thirdgen seats are wornout and are probably worse than what you currently have in your car. door panels when i asked were usually less than $50/each, but the cardboard gets moldy quickly after it sits in the yard with the windows open.
also note that seats from other general motors products will fit in your vehicle. have personal expierence with recent model grandam buckets. (have a very factory look when installed in a thirdgen)
have acquired a couple complete sets of used thirdgen seats in nice shape in the past for $100-$150 a set. but selection is now very limited, since the majority of the thirdgen seats are wornout and are probably worse than what you currently have in your car. door panels when i asked were usually less than $50/each, but the cardboard gets moldy quickly after it sits in the yard with the windows open.
also note that seats from other general motors products will fit in your vehicle. have personal expierence with recent model grandam buckets. (have a very factory look when installed in a thirdgen)
TGO Supporter
iTrader: (1)
Joined: May 2002
Posts: 2,480
Likes: 2
From: El Paso, Texas
Car: 1987 IROC Z
Engine: 350 TPI L98 block
Transmission: 700R4
100 bux
I picked up my 4th gen red and black seats at a junk yard for 100 bux... hit the junk yards, and find the most funked up ones you can ( that have an electric controls) and offer 100 bux, likely they will take it, and take it to be redone...
Thread Starter
Junior Member
Joined: Apr 2002
Posts: 35
Likes: 0
From: San Deigo CA
Car: 1984 camaro Z28 and 1997 camaro RS
Engine: 305 HO in the Z and 3.8 V6 in the RS
Transmission: 700R4 in the Z and 5 speed in the RS
got seats
I got the interior today. I went to the yard this morning to look for some part for my monte carlo and As I was about to leave they came thru the gate with a trashed 84 Z28(looked like they hit some thing really hard on the front end) so i waited for them to unload it to see if the interior was any good. it is almost perfect it has just a little rip in the outside edge on the drive side. the back seat looks as if noone has ever sat on it. i do not have a digital camera or else I would put pics up. but I got the full interior seats and door panels 100 bucks.:lala: :lala:
Thread
Thread Starter
Forum
Replies
Last Post
Zachattack0925
Tech / General Engine
2
Aug 12, 2015 09:54 PM
Zachattack0925
Transmissions and Drivetrain
4
Aug 12, 2015 09:52 PM





