gauge pods?
Thread Starter
Senior Member
Joined: Oct 2002
Posts: 603
Likes: 0
From: Ohio
Car: 1985 Iroc-z
Engine: 355 sbc
Transmission: 700r4
gauge pods?
Yeah I want some gauge pods, but I don't want them to be for the pillar or the panel thats top of the window.
What I want to do is have the cone shaped plastic n mount it under the two vents in the center above the console but I don't want to buy a pillar pod n attempt to modify it.
Does anyone know where I can get a gauge pod holder that i'm looking for?
What I want to do is have the cone shaped plastic n mount it under the two vents in the center above the console but I don't want to buy a pillar pod n attempt to modify it.
Does anyone know where I can get a gauge pod holder that i'm looking for?
Supreme Member
iTrader: (1)
Joined: Feb 2000
Posts: 7,964
Likes: 4
From: Norfolk, VA. USA
Car: 86 Trans Am, 88 Formula
Engine: 95LT4, 305TPI
Transmission: T56, T5
The one for the new mustangs might work.
It is made for the clock area in the center of the dash.
Maybe flip it over and mount where you need to.
I'll see if I can find a pic.
The pillar ones don't look that bad.
I have a triple one in my car,
It is made for the clock area in the center of the dash.
Maybe flip it over and mount where you need to.
I'll see if I can find a pic.
The pillar ones don't look that bad.
I have a triple one in my car,
Last edited by Zepher; Apr 12, 2003 at 02:09 AM.
Thread
Thread Starter
Forum
Replies
Last Post
