I took off the door trim to figure out where the previous owner routed the power for the amp. When I took off the trim plate on the bottom, I noticed that the spot welds are broken under the trim piece. Is this an easy fix? I plan on getting subframe connectors, how should I fix this properly?
Thanks.

 

with the suspension loaded (like just sitting on a level surface) you could just tac weld with a mig i would think to re-weld the factory welds, you install subframe connectors the same way with the suspension loaded like on a ride on lift.

 

So the car is not completely screwed. I can fix this back and won't mess up the frame geometry.
Thanks