Looking for opinions on interior
#1
Moderator/TGO Supporter
Thread Starter
Join Date: May 2001
Location: Bloomingdale, IL , United States
Posts: 2,481
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1997 Z28
Engine: LS1
Transmission: T56
Axle/Gears: 3.42
Looking for opinions on interior
I have everything out of my car except for the dash right now. I am in the middle of floor board repair.
I have purchased new carpet, and a new headliner. I will also be going 4th gen with my seats.
My question is this, i was going to use kyrlon fusion paint to make my plastic rea r pieces look new again. But after looking at them, i realize they could look new with a good cleaning.
Actually my question starts here, what product will clean those well without giving them a too much armor all look.
I just want a clean look.
Or, if i do krylon fusion them, what should i use to prep the surface before i spray them? Should i hit them with some 2000 grit sandpaper first?
Thanks
I have purchased new carpet, and a new headliner. I will also be going 4th gen with my seats.
My question is this, i was going to use kyrlon fusion paint to make my plastic rea r pieces look new again. But after looking at them, i realize they could look new with a good cleaning.
Actually my question starts here, what product will clean those well without giving them a too much armor all look.
I just want a clean look.
Or, if i do krylon fusion them, what should i use to prep the surface before i spray them? Should i hit them with some 2000 grit sandpaper first?
Thanks
#2
Supreme Member
Join Date: Jun 2002
Location: North East GA
Posts: 2,221
Likes: 0
Received 44 Likes
on
40 Posts
Car: 1989 Firebird
Engine: 5.7 LS1
Transmission: T56
When I had mine out I washed them with dish soap, and then sprayed them down with mequires, and wiped them down, mequires doesn't have that greasy feeling.
Look at page 5 of my cardomain for the end result.
Look at page 5 of my cardomain for the end result.
Thread
Thread Starter
Forum
Replies
Last Post