so i have an 86 camaro that had the electronic quadrajet 305 in it. the car is a total make over now and i would like to install some guages since my old ones will not work (i took all the wiring out) i was thinking of getting the covan classic guage cluster and buying some lunar guages for it. my question is how do i wiring up the blinkers and highbeems? the lights and beams work now, but i'd like to get the flashing arrows on the dash and the highbeam signal there to (for inspection purposes) will that cluster and guages clear the back of where my old guages sat? this is what my cluster looks like now

 

i've included a picture of what my old cluster looks like. as you can see, its the model where the tach was replaced with the fuel guage. i'm also wondering where the voltometer plugs into and how i wire up an aftermarket fuel guage to my stock lines. i'm sure its very simple but i'd like to know how to go about it before i start. i realize that with the aftermarket guages i'll have to run a seperate line from the guage to its destination since i yanked all my old wires...