how do i fix this peice?
Thread Starter
Supreme Member
iTrader: (1)
Joined: Feb 2003
Posts: 1,143
Likes: 5
From: check under the car
Car: White 25th Anniversary RS
Engine: lt1
Transmission: t56
Axle/Gears: 4:10
how do i fix this peice?
im trying to repair this corner of my 92 front spoiler. im gonna v out the crack fill one side with plastic adhesive then when it dries im gonna do the back then finish it up with dura glass. any suggestions??
Senior Member
iTrader: (3)
Joined: Dec 2004
Posts: 638
Likes: 0
From: Mass, Boston
Car: 1988 GTA Black notchback
Engine: 1991 L98 355 TWIN Superchagred
Transmission: 700r4 shift kit 2500 stall
Axle/Gears: www.cardomain.com/id/gtafanatic
the right way to fix this would be to get it plastic welded and do both sides then i would sand down the front side untill it is flush if you still see imperfecions i would skim coat it with plastic bondo witch is green. for extra support i would put a bit of fiberglass/mat, or bondoon back side.
Member
Joined: Nov 2004
Posts: 183
Likes: 0
From: Illinois
Car: 55 Chevy (the only one that counts), 80 TA, 85 TA, 87 FB
Engine: BBC, BBC, SBC, none
Transmission: M-22, TH400, TH350, none
3M Makes a flexible plastic 2-part epoxy that repairs urathane plastic. just V-cut your crack and fill with the epoxy. Reinforce the back of teh repair by building it up with extra epoxy. Its an easy fix.
Senior Member
Joined: Jun 2004
Posts: 692
Likes: 12
From: North Carolina
Car: 1984 TRANS AM AERO (PAINT SO DEEP
Engine: 305 CARBED
Transmission: 700 R-4/Vette Servo mod
DO NOT USEBONDOFIBERGLASSORPOLYPUTTY!!!!!!!!!!!!!!!!!!!!!!!
AGAIN!!! I have outlined a repair method please do a search. I have also decided to do a tech article on the subject, that I hope will get a sticky.
This is a foolproof method and WILL NOT FAIL!!!!
AGAIN!!! I have outlined a repair method please do a search. I have also decided to do a tech article on the subject, that I hope will get a sticky.
This is a foolproof method and WILL NOT FAIL!!!!
Thread
Thread Starter
Forum
Replies
Last Post