Where to buy new trim that goes around windsheild...
Thread Starter
Senior Member
iTrader: (2)
Joined: Jun 2004
Posts: 647
Likes: 1
From: South Jersey
Car: 1991 RS Convertible
Engine: 96 LT1
Transmission: T5
Axle/Gears: 3.45 9-Bolt
Where to buy new trim that goes around windsheild...
Hey everyone,
I need to get new windsheild trim. Its that hard plastic that fill the gap between the edge of the windshield & the A pillar/windsheild header. Does GM still carry it?
Thanks in Advance,
Mark B
I need to get new windsheild trim. Its that hard plastic that fill the gap between the edge of the windshield & the A pillar/windsheild header. Does GM still carry it?
Thanks in Advance,
Mark B
Moderator
Joined: Feb 2000
Posts: 7,015
Likes: 2
From: Schererville , IN
Car: 91 GTA, 91 Formula, 89 TTA
Engine: all 225+ RWHP
Transmission: all OD
Axle/Gears: Always the good ones
GM has it.
Also any glass place should be able to get an exact duplicate as well.
later
Jeremy
Also any glass place should be able to get an exact duplicate as well.
later
Jeremy
Senior Member
Joined: Jan 2002
Posts: 506
Likes: 1
From: Miami, FL
Car: 1992 Formula
Engine: 350
Transmission: auto stock
Axle/Gears: 3:42
Ditto, when my front glass was replaced and car painted, they put a new black molding, just like factory, been 3 years now and perfect! Andy
Junior Member
Joined: Mar 2005
Posts: 48
Likes: 0
From: Michigan
My advice would be go to a glass shop and get "wrap around" molding in the same width. The OEM style is "push-in", the wrap around will give better results..it will take care of the wavy effect and it keeps the glass at the right height while curing.
Drew
Drew
Supreme Member
iTrader: (1)
Joined: Sep 2004
Posts: 1,372
Likes: 2
From: Toledo, OH
Car: 1982 Trans Am
Engine: SBC 400
Transmission: 700-R4
Axle/Gears: 9 Bolt 2.77
classic industries has them also, there are 2 different kinds for thirdgens. One is a little thicker than the other I believe...'82-'84 and '85+ I believe.
Thread Starter
Senior Member
iTrader: (2)
Joined: Jun 2004
Posts: 647
Likes: 1
From: South Jersey
Car: 1991 RS Convertible
Engine: 96 LT1
Transmission: T5
Axle/Gears: 3.45 9-Bolt
Just ordered one through the dealership.
I never removed the windshield. I destroyed the old one while taking it off to get the car painted.
I never removed the windshield. I destroyed the old one while taking it off to get the car painted.
Thread
Thread Starter
Forum
Replies
Last Post
Linson
Auto Detailing and Appearance
26
Sep 21, 2015 01:08 PM
