chassis measurements
Thread Starter
Supreme Member
Joined: Jul 2003
Posts: 2,494
Likes: 0
From: Markham
Car: 1990 Camaro
Engine: 355ci
Transmission: TKO-600 5 speed
Axle/Gears: 3.73 10 bolt
chassis measurements
What are hte chassis measurements for a 1990 iroc Z? want to know if my car is still straight
Ive had endless problems with my car since it was slid off the road, no real damage it didnt seem, hopped a curb and took out a tree, only physical damage was a dent to the front left rim that was easily taken out by a wheel repair place, and a small dent in the front left of the bumper, like 3/4 of an inch?
Ive had endless problems with my car since it was slid off the road, no real damage it didnt seem, hopped a curb and took out a tree, only physical damage was a dent to the front left rim that was easily taken out by a wheel repair place, and a small dent in the front left of the bumper, like 3/4 of an inch?
Thread Starter
Supreme Member
Joined: Jul 2003
Posts: 2,494
Likes: 0
From: Markham
Car: 1990 Camaro
Engine: 355ci
Transmission: TKO-600 5 speed
Axle/Gears: 3.73 10 bolt
thanks, question for you guys
I'm just realizing all this now, but i slid the car off the road a couple summers ago right at the end of the summer, the car had almost no damage to it but the front left tire took a good hit.
The next summer the motor died on me, had a bad drivetrain vibration that i thought was just the spun bearings we found in the bottom end. Now theres a new motor in there, balanced as well as the new flywheel, with the new manual transmission, just had the driveshaft balanced, and im starting to get the vibration again. Think the front clip being shifted out like 1/2 an inch could cause this?
I'm just realizing all this now, but i slid the car off the road a couple summers ago right at the end of the summer, the car had almost no damage to it but the front left tire took a good hit.
The next summer the motor died on me, had a bad drivetrain vibration that i thought was just the spun bearings we found in the bottom end. Now theres a new motor in there, balanced as well as the new flywheel, with the new manual transmission, just had the driveshaft balanced, and im starting to get the vibration again. Think the front clip being shifted out like 1/2 an inch could cause this?
Thread
Thread Starter
Forum
Replies
Last Post
darwinprice
Organized Drag Racing and Autocross
17
Oct 11, 2015 11:51 PM




