T-Top Bar for 89 IROC
Thread Starter
Member
Joined: Jul 2005
Posts: 372
Likes: 0
From: Staten Island NY
T-Top Bar for 89 IROC
Just ordered a new GM T-Top bar. How difficult will it be to replace? Is there much to do other than removing the weatherstripping (have new replacement) and the screws that are visible, for it to come off?
Supreme Member
iTrader: (3)
Joined: Dec 2006
Posts: 1,116
Likes: 1
From: Guilford, Connecticut
Car: 1987 Trans Am
Engine: 355
Transmission: t56
Axle/Gears: 3.73
Re: T-Top Bar for 89 IROC
there are also screws under the weatherstripping if I remember correctly. then some adhesive holding it on.
Supreme Member
Joined: May 2005
Posts: 2,220
Likes: 68
From: Atlanta
Car: '02 T/A WS6, '91 T/A, '91 Camaro RS
Engine: LS1, LB9, L03
Transmission: T56, 700R4, 700R4
Axle/Gears: 4.10 10 bolt, 2.73 10 bolts
Re: T-Top Bar for 89 IROC
Any idea on what kind of adhesive they use in this area at the factory? I'm replacing mine too and can't seem to figure out what it is.
Supreme Member
iTrader: (3)
Joined: Dec 2006
Posts: 1,116
Likes: 1
From: Guilford, Connecticut
Car: 1987 Trans Am
Engine: 355
Transmission: t56
Axle/Gears: 3.73
Re: T-Top Bar for 89 IROC
I don't think I put any adhesive under the bar, just screwed it in then put the weatherstripping in. I may have put a little caulking, dont remember 100% though.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
1Aauto
Sponsored Vendors
0
Aug 24, 2015 03:40 PM
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM
