stupid question but need help
Thread Starter
Junior Member
Joined: Aug 2007
Posts: 87
Likes: 0
Car: 1992 camaro
Engine: 3.1 v6, CAI
Transmission: t5
Axle/Gears: eaton posi
stupid question but need help
Ok, this is really really stupid but bear with me please..... I can not get my stupid liscence plate and bracket off, any suggestions please thx!
Senior Member
iTrader: (1)
Joined: Jun 2007
Posts: 631
Likes: 1
From: Colorado Springs
Car: 1987 Camaro SC
Engine: 305 LB9
Transmission: 700R4
Axle/Gears: 3:42
Re: stupid question but need help
If you are talking about the back license plate, just lower it and remove the two screws (one on each side) and it should come right out.
Thread Starter
Junior Member
Joined: Aug 2007
Posts: 87
Likes: 0
Car: 1992 camaro
Engine: 3.1 v6, CAI
Transmission: t5
Axle/Gears: eaton posi
Re: stupid question but need help
Its the front plate. No i dont know the steps to do it, i was just gonna take the grill of then work at it from there but i cant get the last screw off cause the plate and bracket are in the way.
Supreme Member
iTrader: (10)
Joined: Oct 2007
Posts: 1,881
Likes: 2
From: Fl.
Car: 83 Trans Am / 96 Jeep XJ
Engine: 355 / 4.0 I6
Transmission: TH350 / Auto
Axle/Gears: 3.23 10-bolt / 4wd
Re: stupid question but need help
if yours is like my old car was, theyre bolts, and have nuts. My nuts were siezed (Insert joke here) and had to be gripped with pliars, hope that helps 
Supreme Member
iTrader: (28)
Joined: Jul 2006
Posts: 1,564
Likes: 2
From: ocklawaha FL.
Car: 81z-28,89gta,91z-28 03 1500
Engine: 355,L98vette tpi,327
Transmission: TH350/700R4/700r4/4l80E
Axle/Gears: 3;73/3;27/2;73/3;73
Re: stupid question but need help
after you have it removed you will see a few screws that hold the bracket to the bumper cover (remove them)
after those screws are removed that bracket should fall into your hands.
Thread
Thread Starter
Forum
Replies
Last Post