I picked up a couple of rear view mirrors with the reading lamps in them.
I got the wires for them with the lights.
I would like the lights to come on when I open the doors or turn on the interior lights as well as come on when I use the switches on the mirrors.
I've seen some third gens with these type of mirrors installed from the factory, where do I connect the wires so that I can get them to operate the way that I described above.
Thanks

------------------
Zepher
'86 Pontiac Trans Am WS6, LG4 305, 5 Speed, CF DF Clutch,
Edelbrock 1406 Carb, Edelbrock Performer RPM 7101 Intake Manifold.
Edelbrock Open Element Air Cleaner: Flowmaster Exhaust, 160* Thermostat,
Grant GT Steering Wheel, MSD HEI Coil, Taylor 8mm Wires, Leather 96 Camaro SS Seats,
Alpine CD+Changer,Alpine V12 Amps, Premier TS-1040C Subs, Polk Audio highs/mids.
Best ET: 14.94@91.67
High Speed Run: 157mph
WS6 Trans Am

 

just run the wire under your headliner,tie into your dome lite.It should work like you described, the mirror should have a two way switch on it as well.

Hope I helped........Hammer

------------------
1987 GTA,Black&Sinister.
383 ci TPI,700R4, 12 bolt,3.73:1,SSM lift kit,
home-made cold air induction.12.20's,no juice......yet

 

Black wire goes to ground.
Orange wire goes to constant 12V power source (find and splice into one under the dash).
White wire connects to the pin switch on the door jamb.
That's it....

Pete

------------------
Pete's Place
HiOutput Virtual Racing Team

 

Thanks guys.
I have an extra mirror with lights and the wires for it if anyone wants it.
$25+shipping.

 

I hooked up my mirror lights. wasn't too hard. took off the overhead console wrong, tried to remove all the screws instead of just the two in the dome light and sliding the console forward. At least now I know how to remove/install the console.