I know this has probably been asked before, but I get a LOT of wind noise at the front of the driver side t-top. Surprisingly, I have no tears in the weather stripping, and no water leaks at all. Just that damn wind noise. Starts about 50mph and gets worse the faster I go. Any suggestions to quiet it down some? Also the tops are in real good shape.

------------------
'92 firebird t-tops
305tbi,670cfm tbi, 2 1/2" Dynomax catback, 9x3 K&N open element

 

Could try slightly lowering that particular corner of your T-top.I had the same prob,that fixed her right up.

Brent

 

What?

------------------

FOR SALE - email me

 

the place where the t-tops lock in at, you can take off the trim, and adjust that, that fixed mine also...

 

Thanks a lot! I didn't know the tops wre adjustable. Sounds like the right answer.

 

To 92blackbird..Yeah like the above post,just remove your T-top.The location where your T-tops latch at,remove either side of trim by removing the small black screw..slightly pull down on the trim to gain access to a small bolt,loosen the bolt,you should then be able to slide up or down the small mounting plate,the slighest movement will lower or raise your T-tops,but i kept on having the problem of the mounting plate sliding back into the position that it was in orginally in..so all i did was hold the plate with one hand very tightly and slowly tightened the bolt to spec..secure your trim pieces back,install your T-tops back into your car.Crank her up,take off onto the road and find a Mustang to smoke and hopefully the only wind noise you wil hear will be the noise of you passsing his behind!!....hehehe..:8^)

Brent

------------------
---------------------
Toys currently owned:
-91 MPFI Firebird
-97 Grand-Am GT
-96 Extreme Sonoma
-91 Suzuki GTS500E

 

Great help guys. Going to do that this a.m..
I'll let you know the results.

 

Hey One Eyed Jack

Nice looking car in the pic. I take it that is you on the right

 

Thanks for the help!!! It worked great. No more t-top noise. Now it's just on th eside windows.