Edit: For all future readers, this is fixed by tracing the tube down to the base and removing them by pulling firmly, separating the tubing without dissembling the whole grille portion.

I am trying to replace my windshield wiper arms. I managed to replace the arms, but I don't know how to replace the tubes connecting to the washer reservoir.
What do I do to fix this?

 

Are you talking about the rubber tubes that transfer the fluid?

If so bring a small amount to an auto parts store and get a few feet in bulk. Should be cheap.

 

I have new arms to install, and the tubing is attached to the old ones. I'm asking how I remove the grille/plate to get to where the tubing runs, under the arms.. unless there's a way to do it without removing the grille or plate.

 

These grills/plate?...see arrow/note in windshield...

 

sorry,text came out so small...but red line shows the part you are referring to?...

 

sorry text ended up so small..the red arrow points to part you are referring to?.....

 

Yes, at the time that was the part I was talking about... but I've since edited the OP with updated information.

Thank you for responding!