Removing the rear seats
Removing the rear seats
I have a 92 camaro RS. I was wondering if anyone knows how to take the rear seats out and how easy it is.
I just wanted to check the boards first before i even think about looking at the seats.
Thanx
I just wanted to check the boards first before i even think about looking at the seats.
Thanx
Member
Joined: Sep 2001
Posts: 283
Likes: 0
From: Rochester, NY, USA
Car: 1986 IROC-Z
Engine: 355 TPI
Transmission: 700R4
Axle/Gears: 3.23 Posi
Just a big bolt under the center of each seat. And then it's just velcro-ed on to the carpet from there. No big deal. 5mins to remove both...
You didn't lookin the right place then,,,
seat bottom,,has one bolt,dead center,on the bottom,front of the seat,going backwards twords the back of the car, bolting it to the floor,and velcro holding the back,,,
then the top part has a bolt holding it on right in the outside corner of each one and the inside is held on to the pin that it welded to your car,once you get the bolt out just pull straight out from the side,(where it seems to be still held on)or if you have a 3 piece back seat the top piece is 1 piece with 2 bolts in it.One in each corner,and these are easier to get out with the bottoms out,but not imposable.
By the way I think 13 mm for all.
seat bottom,,has one bolt,dead center,on the bottom,front of the seat,going backwards twords the back of the car, bolting it to the floor,and velcro holding the back,,,
then the top part has a bolt holding it on right in the outside corner of each one and the inside is held on to the pin that it welded to your car,once you get the bolt out just pull straight out from the side,(where it seems to be still held on)or if you have a 3 piece back seat the top piece is 1 piece with 2 bolts in it.One in each corner,and these are easier to get out with the bottoms out,but not imposable.
By the way I think 13 mm for all.
Thread
Thread Starter
Forum
Replies
Last Post





