ordered some new brakepds but thy wont fit on the frontbrakes!

So i called the local shop and i told them they were too short.
They told me to check how much pistons there are in a caliper, so i checked and there are 2 of them in each caliper.

Is that special or anything?

I also have to shorten my driveshaft, so i wanted to cut a piece out and weld it again, but after i cleaned the shaft i noticed it is made of aluminium! *sigh* are they always of aluminium? or is that special too?

im getting kinda frustated lately.

 

is this a joke or are you bragging?

 

I wouldn't complain. Sounds like you have 1LE brakes and you confirmed the aluminum DS part.

Most people would be jumping for joy...

 

I also have to shorten my driveshaft, so i wanted to cut a piece out and weld it again, but after i cleaned the shaft i noticed it is made of aluminium! *sigh* are they always of aluminium? or is that special too?


im doing that dan60 axle change, so that driveshaft has to be shorter

 

ill send you my steel one to cut in exhange for your aluminum one. ill even pay shipping. pm me if interested.