Roll Control
Thread Starter
Member
Joined: Apr 2010
Posts: 129
Likes: 0
Car: 74 Nova prostreet 87 Iroc Z28
Engine: 427 671 blower 350 Built
Transmission: 700R4 both
Axle/Gears: Dana 60 an a 323 posi.
Roll Control
Does anyone have Hurst line lock in an 87 z .The directions aren't to clear. Pictures an a diagram would be nice to tell where the lines go. Thank You Larry.
Joined: Aug 2006
Posts: 12,812
Likes: 109
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: Roll Control
it should just have a "in" and an "out". Its installed on the front brake circuit. The lines from the master goes to the "in", the line from the "out" goes to the propvalve. The front circuit is on the back of the master cylinder, they smaller sized lines.
Thread
Thread Starter
Forum
Replies
Last Post
