amp overheating :/
Thread Starter
Supreme Member
Joined: Apr 2009
Posts: 2,852
Likes: 2
From: Scottsdale, AZ
Car: 89 GTA/93 S13/91 Si
Engine: 5.7 350 TPI
Transmission: 700R4
Axle/Gears: 3.23
amp overheating :/
okay
so a couple of times when ive really pounded my system..the bass amp for my sub cuts off and the little light on it goes red *usually green..guessing its overheating?? southern cali weather probly doesent exactly help it lately either..so
the question is.
is there any way i can still bump my system without overheating the amp?
thanks
Mikey
Pic
vvvv
so a couple of times when ive really pounded my system..the bass amp for my sub cuts off and the little light on it goes red *usually green..guessing its overheating?? southern cali weather probly doesent exactly help it lately either..so
the question is.
is there any way i can still bump my system without overheating the amp?

thanks
Mikey
Pic
vvvv
Supreme Member
iTrader: (4)
Joined: Mar 2009
Posts: 3,079
Likes: 4
From: Pepperell, MA
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: amp overheating :/
How do you have your gains set? If they are set too high, you may be causing the amp to go into protect mode. If it is too hot to physically touch, you may have a possible wiring issue or just pushing it too hard. What ohm rating is your sub and how is it wired to the amp? (bridged?)
Junior Member
Joined: Jul 2009
Posts: 13
Likes: 0
From: Lake Providence, LA
Car: 1987 Chevrolet Caprice Brougham
Engine: 425hp 350 bored .060
Transmission: 700r4
Axle/Gears: 8.5 3.42 locker
Re: amp overheating :/
You need to check your ohm load. Most of the time when amps are getting hot like that it always come back to be a wiring problem. Do you have a good metal ground and all connections are good. Hope you get it fixed properly.
Thread Starter
Supreme Member
Joined: Apr 2009
Posts: 2,852
Likes: 2
From: Scottsdale, AZ
Car: 89 GTA/93 S13/91 Si
Engine: 5.7 350 TPI
Transmission: 700R4
Axle/Gears: 3.23
Re: amp overheating :/
okay..thanks alot to both of u =] my ground was coming off AND my gain was way to high. thanks guys^^
Thread
Thread Starter
Forum
Replies
Last Post
raymondandretti
Electronics
1
Sep 27, 2015 06:43 PM





