does anyone know where I can get the dimensions for a box to hold my single twelve that will go in hole in the truck. . I still want to have some room to put somethin else.

------------------
1987 Pontiac Firebird Formula 350
1 of 2,384 made, Black with Silver decals
350 TPI
700R-4 Tranny with TCI shift kit and Corvette servo with TV boost sleeve
TCI saturday night special 2200-2500 stall converter
WS6 supsension
SLP headers with full 3" exhaust exiting through an SLP dual 2.5" tip muffler
SLP airfoil
180 degree thermostat
hypertech "performance" chip
3.73 rear
Viper talkin alarm with remote start
My 383 is in the process of being built right now, hopefully to make it's debut by middle December. . . many more mods to come in the summer. . maybe some experimentations with juice. . have some track times my independence day.

 

you can find the dimentions at any car audio online store. www.sounddomain.com or www.crutchfield.com are both good. just look up a pre-built truck box. they should have the specs there.

 

truck or trunk?

 

my bad, i think we both had some spelling errors. all i did was measure out the bottom section of the well. got a new alpine type-r 12 dvc goin in down there. my rough specs for that error (make sure to take with a grain fo salt): 13 3/8" W, 9" H, 31" L. or in terms of ft: 1.11 x .75 x 2.58. maybe helpful. i'm tryin to make a custom box that will fix flush. i learned the hard way to not show off a system...

 

That's a lesson that most of us learn the hard way at one time or another.

Anyway, as for dimensions, all the dimensions you need are already in your tape measure waiting to escape.

------------------

The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
Custom Thirdgen Subwoofer Enclosures
"I didn't know a bored out Ford could go so slow" -Shenandoah