Porting stock intake
Thread Starter
Junior Member
Joined: May 2002
Posts: 69
Likes: 2
Car: '89 RS
Engine: LS3
Transmission: TR6060
Axle/Gears: 3.42, 10-bolt
Porting stock intake
David Wizard says in his book "How to build Chevy small blocks on a budget", that ported stock intake is as good as some decent aftermarket intake.
Does somebody know about that? Is somewhere instructions about porting stock intake?
Thanks!
Does somebody know about that? Is somewhere instructions about porting stock intake?
Thanks!
Member
Joined: Oct 2002
Posts: 386
Likes: 0
From: Edmonton AB Canada
Car: 86 Firebird
Engine: 355 4 bbl
Transmission: TKO 600
Axle/Gears: 3.73 L/S
Check out Vizard's "How to Build Horsepower Vol II", there is a chapter on modifying a cast iron Q-jet manifold for improved torque right from idle up to 6K.
He also shows some of the mods that Brzezinski performs on an iron Q-jet intake, these get quite involved but makes for a hot stock intake that would fool anybody looking at it installed on an engine.
He also shows some of the mods that Brzezinski performs on an iron Q-jet intake, these get quite involved but makes for a hot stock intake that would fool anybody looking at it installed on an engine.
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM