I bought a demon carburetor and I am trying to make sure I purchased everything I will need for my swap. Will this carburetor bolt to my manifold? If not what or where can I get an adaptor? Oh I have an Edelbrock Performer EGR part # 3701 picture below.

 

Well after reading I think I will need an adapter so can anyone tell me witch of these I can use? Summit part #’s

EDL-2732 it's just looks like a copper gasket but says it's for Square boar carburetor on a spread boar manifold.

Or

TRD-2066 this looks more like a 1” spacer but oddly shaped but my fear is that it is to tall to fit under a stock hood with a 3” filter

 

No adapter needed.

 

wow really man i was so afraid i would have to put my cowl hood on again i just put my stock hood back on cause i loved the stock look much better. thanks a bunch man!!!! your a $$$ saver